Choose how the kitchen opening should feel, and how Michelle can enjoy the nook fire from the Oriel seat.
Revised to your four corrections. Ashlar Muskoka Grey stone follows the exterior direction; Great Room wood ceiling infill matches the soffits; the covered option is one flat wall up to the roof supports; the nook fire is now about 34 inches wide rather than 47.
The Rumford 1000 remains the Great Room study. The nook gas is a smaller, taller three-sided proposal. These images and model references support a design decision; final product, heat output, installation and owner review remain separate. Earlier R1 studies · superseded by these corrections
See the masonry and ceiling references used
The recorded masonry direction is 1-inch Ashlar Muskoka Grey, with varied rectangular courses and silvery-grey granite banding. It follows the August 27 owner preference and the exterior study, intended to echo the rock above Michelle’s bedroom. The warm wood ceiling follows the earlier Great Room visualization marked “soffit continuity correct.” The lower kitchen ceiling remains pale plaster.
Exterior material appearance reference. This is a generated study, not a supplier sample.Earlier visualization · ceiling/soffit material continuity only. Its older layout and fireplace are not adopted.
All three views now have the warm wood Great Room ceiling infill, matching the soffits. The covered option changes the whole vertical wall face above the opening; the exposed options retain the visible I-section. The higher perpendicular beam and timber roof supports remain.
The beam and the wall above it form a continuous pale plaster plane up to the sloping ceiling and roof supports. It meets the adjoining wall without a separate box, projecting lip or setback.
The opening head stays at its study height. Final lining thickness, attachment and fire protection remain to coordinate.
Exposed black · strongest fit
Connects the kitchen hardware, black window frames and the higher steel. It gives the opening a clear architectural edge without adding another warm material.
Specify a matte or low-sheen sample, prepared welds and tidy connections. Ordinary structural steel is not automatically finished for close viewing.
Rust-brown patina
A warmer, more expressive accent beside the walnut, oak and grey stone. It draws more attention to the beam and needs a physical sample beside the kitchen finishes.
Show a controlled, sealed decorative finish or separate finish skin. Do not rust the structural member or disturb a required protective coating to obtain the colour.
Compare two beam images with a sliding divider
Beam size, ceiling levels and what remains to coordinate
The permit roof framing identifies SB104 as W18×55. The retained model uses an approximately 18-inch-deep I-section. Its underside is 113½ inches above the main floor; the illustrated covered opening underside is 112¾ inches. The new wall face extends continuously to the existing sloping ceiling, concealing the transverse steel and its short supporting stub without removing either.
The lower kitchen ceiling stays pale and flat; the Great Room ceiling and matching lake soffit use warm wood infill between dark supports. Roof slopes, ceiling levels and existing supporting members stay in place. No option assumes a column can be removed.
Nada and the steel supplier need to confirm the current shop drawings, end connections, support arrangement and the required fire-protection system before a finish is specified. AISC explains how exposed steel finishes must coordinate with any required protective coatings; that guidance does not determine the Ontario requirement for this house.
The revised fire is about 34 inches wide and 21 inches high: roughly 27% narrower than the earlier 47-inch ribbon. This taller, more compact proportion keeps the nook welcoming while the projecting end glass preserves a view of the flame from the Oriel seat.
A compact three-sided fire, with the final product still to choose.
The Marquis Enclave 34 bay supplies a smaller proportion reference. Its published viewing envelope is about 34⅛ × 20 15⁄16 inches. These are not scaled-down CB40E units: the old wide Regency reference has been retired from this study.
The illustrated 8-inch projection is a design assumption, to be checked against the chosen appliance and casing. The stone chase stays in place; only the local aperture, plinth and cap change. The masonry now follows the same Ashlar Muskoka Grey direction as the exterior.
A smaller body does not guarantee gentler heat. The reference Enclave’s published propane input range is 19,000–24,000 BTU/h, so it is a size reference, not a heat-output recommendation for the nook. Ask the installer for the lowest practical output and suitable heat distribution before selecting a unit.
Visibility from the Oriel seat
Move the seated position along the bench to see why end glass helps. Lines show viewing directions only; they do not certify furniture clearances or a gas installation.
Plan convention retained: lake / north is down. Furniture and chase positions come from the current model; the coloured bay is the proposed addition.
Existing stone chaseProposed baySeated view
Fit, heat and the two separate appliances
The main Rumford wood fire and the nook gas fire are two independent appliances facing opposite sides of the chase. This is not a see-through Rumford conversion. A basic envelope sketch is insufficient to approve their coexistence.
The gas installer and Nada must resolve casing separation, service access, safety barriers, gas supply, vent route, air intakes, manufacturer-specific heat-outlet free area and clearances to the bench/bookshelves. The compact proposal does not inherit the previous CB40E outlet or framing requirements. The exact outlet and barrier arrangement remains unresolved in these images.
The revised near-square front is intended to feel like a small hearth rather than a long ribbon. Compare flame appearance and comfortable minimum output in the exact propane configuration, including any heat diversion, before ordering. The flat-front image remains a visual baseline rather than a certified installation configuration.
The retained visible opening is 28¼ inches wide × 29 inches high, matching the current manufacturer installation drawing. The masonry has been revised to the exterior’s Ashlar Muskoka Grey direction, with varied rectangular courses and silvery mineral banding. The chase wraps its returns; the adjoining divider remains plaster. Warm wood ceiling infill matches the soffit direction.
The Rumford 1000 is the study model Chris confirmed today. Its compact, tall opening gives the stone vertical emphasis and retains the current furniture, hearth and adjacent-nook arrangement.
What still needs a final detail
Confirm the current RR1000C casing/framing, hearth protection, mantel/sconce positions, floor support, chimney route and outside-air connection against the installer’s package. The web summary and current manual differ slightly on casing width: the manual’s installation dimensions govern.
Confirm the Rumford 1000, choose whether the nook bay gives the visibility Michelle wants, and compare the black beam against the pale cover and patina. My design preference is black exposed steel + the shallow nook bay, subject to the installation checks.
Alyssa, Nada & the fireplace / steel suppliers
Price the exact fireplace configurations and shared-chase detail. Resolve the steel shop drawings and exposed-finish/fire-protection requirements. Bring one black sample and one muted rust-brown sample beside the actual kitchen and stone materials.
Cost evidence and current gaps
Item
Evidence
What the number covers
Rumford 1000
CAD $18,000.00 before HST
Brendan via Alyssa, September 30, 2026: rough chimney + installation ballpark. Masonry/finish scope, current price, fees and final installed detail remain to confirm.
Compact three-sided nook gas
New configuration · quote required
Quote the exact compact propane configuration. The earlier gas ballparks and the retired wide CB40E appearance reference do not price this proposal.
Covered / black / patina beam
No comparable project quotes located
Obtain separate prices for lining or preparation/finish, connections and any required fire protection. Patina appearance is not evidence of a saving from omitting paint.
Comparison information only. No project forecast, purchase approval or order release has changed.
Keep comparison notes on this computer
Optional personal worksheet. Saving here records a local draft only; it does not approve a room stage or send anything to the builder.
Sources and scope
Current registered house: R23, October 23, 2026, with isolated R2 decision-study changes. The October 20 Oriel plan governs that later geometry. The August27 Ashlar Muskoka Grey preference and the earlier soffit-continuity visualization now govern these material studies. The covered-beam wall and compact gas aperture are versioned proposals; the working house, prior models and owner approvals remain intact.
Photographic studies are visually checked appearance references, not dimensionally certified final photographs. Generated texture, fire and daylight remain illustrative. Original attempts, prompts, native geometry and earlier reviews are retained.